Experienced DIYer - 15+ years
THIS IS NOT A MOBILE SERVICE
Location: Off of route 74, Honey Valley Road.
Type of service provided:
1\.
Front or Rear brake pad replacement -$60
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
Parts required – brake pads, 1 can of brake cleaner
I will do maintenance on the caliper pins (clean and apply lubricant) and apply caliper lubricant where pads are seated on the caliper bracket (wire brush and apply lubricant)
Note:
1a.
IF caliper is done in conjunction with brake pad replacement – additional $15 labor per caliper
Additional parts required – caliper(s), 12 oz bottle of brake fluid (per two calipers), 1 can of brake cleaner (per two calipers), one small tube of blue Loctite.
Brake fluid required for bleeding newly installed caliper (remove air).
Loctite is for use on caliper bracket bolts to ensure bolts do not come loose.
There is a core charge for the caliper which is refundable once old caliper is returned.
1b.
IF rotor is done in conjunction with brake pad replacement – additional $10 per rotor
Additional parts required – rotor(s), 1 can of brake cleaner (per two rotors), one small tube of blue Loctite.
Loctite is for use on caliper bracket bolts to ensure bolts do not come loose.
2\.
Caliper replacement (if done separately) - $35 per caliper
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
There is a core charge for the caliper which is refundable once old caliper is returned.
Parts required – caliper(s), 12 oz bottle of brake fluid (per two calipers), 1 can of brake cleaner (per two calipers), one small tube of blue Loctite.
Brake fluid required for bleeding newly installed caliper (remove air).
Loctite is for use on caliper bracket bolts to ensure bolts do not come loose.
3\.
Rotor replacement (if done separately) - $30 per rotor
Additional parts required – rotor(s), 1 can of brake cleaner (per two rotors), one small tube of blue Loctite.
Loctite is for use on caliper bracket bolts to ensure bolts do not come loose.
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
4\.
CV Axle replacement - $90 per side
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
5\.
Wheel bearing and Hub Assembly – $90 per side
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
Note: If Hub or Bearing needs to be pressed out, there will be an additional $55 fee per side.
6\.
Upper/Lower Control Arm and/or ball joint replacement - $90 per side
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
Note: Ball joint needs to be pressed out, there will be an additional $25 fee per side.
7\.
Alternator - Labor as follows:
a.
For 4 cyl vehicles - $60
b.
For 6/8 cyl vehicles - $90
c.
For vehicles that require additional accessories or other parts to remove, - $90-120.
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
There is a core charge for the alternator which is refundable once old caliper is returned.
8\.
Oil changes - $30
Parts provided by you or at your request, I can purchase.
I can get between 10-20% discount on parts at Auto Zone, Advance Auto, or Napa.
Parts required – oil, filter
Note: If your vehicle requires a special tool to remove filter, you must provide.
9\.
Miscellaneous (water pump, thermostat, spark plugs, abs sensor, brake lines, brake hose, etc.
) – Call and discuss.
My hourly rate is $30 an hour.
I GUARANTEE MY WORK.
If there is an issue with the install, I will ensure it is resolved.
However, part failure / warranty issue, you must handle through the vendor and rework, additional labor applies.
Note – If there are issues with removal due to excessive corrosion, i.
e.
, bolt breaks, sensor breaks, etc.
, there will be additional labor and parts charge.
I will inform you.